HP-SST-D00 Dual Wall Solder Seal Sleeve

Product Details

■ Application:

Transparent insulation sleeve provides encapsulation,inspect, strain relief, and insulation.Pre-fluxed solder provides controlled soldering process.One piece design, it consists of transparent heat shrinkable sleeve and fluxed solder. Provides insulation and lower the installed cost. Color hot-melt glue on two ends of heat shrinkable tube, connecting wires to component terminals, such as motor tabs, connector pins, and switch terminals,it is very convenience to use the exact wire dimension. Provides insulation, inspection, strain relief and water proof. The color tube appear a proper wire size and makes installation easier and decrease the installed cost


■ Characteristics:

●Shrinkage ratio 2:1
 ●Waterproof for wiring splices
 ●Transparent sleeve provides precise inspection
 ●Easy control soldering process      
 ●Minimum Shrink Temp. 60℃
 ●Minimum Fully Recover Temp.110℃
 ●Fully melt temperature of solder: 138℃

 

 

   




■ Technical Data:


Operating temperature-55℃~125℃
voltage Resistant>600V
Protection typeIP67
Volume Resistivity (Ω cm):≥10 15
Dielectric Strength (KV/mm)≥25

■ Size:

 
Product Code
Size Code Color

L Max (mm)

Φ A Min (mm)Cable size
 AWG  (MM2)
HP-SST-D00-01Clear40±1.51.726-24(0.25-0.34)
HP-SST-D00-02Red40±1.52.722-18(0.5-1.0)
HP-SST-D00-03Blue40±1.54.516-14(1.5-2.5)
HP-SST-D00-04Yellow40±1.56.012-10(4.0-6.0)

Other sizes are available upon request.


 ■Color:
 Standard color: Color, Red, Blue,Yellow
 Other colors are available upon request.

Feedback